Main Article Content
Currently, a lot of focus is dedicated to metal hydride alloy and options of their utilization. Mankind must solve energy problems due to constant population growth and use of non-renewable energy sources. The World resources of oil are limited and therefore the mankind must start utilizing the alternative energy sources for example hydrogen. Its known that the hydrogen can be stored by metal hydride alloys what it represents the safety way of storage with absence high pressure and temperature. The process by produce of the alloy with good absorption properties the research does not end. Some alloy absorbs the hydrogen after they produce immediately, however a lot of them need the activation for improvement or starting absorption process. Process of activation is very important for achieving the maximum capacity at moderate temperature.
This work is licensed under a Creative Commons Attribution-NoDerivatives 4.0 International License.
Submission of an article implies that the work described has not been published previously (except in the form of an abstract or as part of a published lecture or academic thesis), that it is not under consideration for publication elsewhere, that its publication is approved by all authors and tacitly or explicitly by the responsible authorities where the work was carried out, and that, if accepted, will not be published elsewhere in the same form, in English or in any other language, without the written consent of the Publisher. The Editors reserve the right to edit or otherwise alter all contributions, but authors will receive proofs for approval before publication.
Copyrights for articles published in IJIER journals are retained by the authors, with first publication rights granted to the journal. The journal/publisher is not responsible for subsequent uses of the work. It is the author's responsibility to bring an infringement action if so desired by the author.
 D. Vyas, P. Jain, G. Agarwal, A. Jain and I. P. Jain: „Hydrogenstorage properties of Mg2Ni affected by Cr catalyst“, Int. J.Hydrogen Energy, 2012, 37, 16013–16017.
 H. H. Cheng: „Special hydrogen storage materials and themeasurement apparatus“, PhD thesis, Institute of Metal Research, Chinese Academic of Sciences, Shenyang, China, 2007,20–25.
 E.D. Koultoukis et. all, „High-Temperature Activated AB2 Nanopowders for Metal Hydride Hydrogen Compression“, online in: https://arxiv.org/ftp/arxiv/papers/1311/1311.4465.pdf.
 Sakintuna B, Lamari-Darkrim F, Hirscher M.: „Metal hydride materials for solid hydrogen storage“, A review. International Journal of Hydrogen Energy 2007; 32,1121-1140.
 L. Zaluski, A. Zaluska, P. Tessier, J.O. Ström-Olsen and R. Schulz, J. Alloys Comp., 217 (1995) 295.
 L. Zaluski, A. Zaluska, P. Tessier, J.O. Ström-Olsen and R. Schulz, Mater. Sci. Forum, 225–227 (1996) 853.
 L. Zaluski, A. Zaluska, J. OStröm-Olsen, „Nanocrystalline metal hydrides“, Journal of Alloys and Compounds, Volumes 253–254, 20 May 1997, Pages 70-79.
 Pierre Millet, Michel Guymont, „METAL HYDRIDES : ACTIVATION PROCEDURES, THERMODYNAMICS AND KINETIC ANALYSIS“, 2IWH 2007, 27-29 October 2007, Ghardaïa – Algeria.
 T. Jacobsen and K. West,” Diffusion impedance in planar, cylindrical and spherical symmetry”, Electrochim. Acta, 40, 255-262, (1995).
 Michael E. Badding, „PROCESS FOR ACTIVATION OF METAL HYDRDES“, Lucent Technologies Inc., Murray Hill, N.J., No.: 292,556, Aug. 18, 1994.